I run N1MM+, but that’s how mine work unless I turn on the K3 monitor. I think
the local printing is done with a loopback inside 2Tone since (at least on
mine) the spectrum windows all go flat during transmit (without the monitor
on). I use three copies of 2Tone and only the main window prints my outgoing.
If David G3YYD is listening he can likely confirm this. But it sounds like you
are ok.
Ken K6MR
From: Gary AL9A
Sent: Friday, 19 September, 2014 14:05
To: rtty@contesting.com, WriteLog Reflector
I am setting up for this weekends BARTG Sprint 75 RTTY contest and am having
a bit of trouble with my clone windows. I am running WriteLog and the
microKEYER II and have used this combination successfully with 2Tone FSK for
several recent RTTY contests at 45 baud. I just setup my 2Tone windows, the
main TX/RX window and two RX only clone windows, to run 75 baud and while
the main window transmits and prints the messages being sent ok, the two
clone windows print mostly gibberish. I don't know what else I can do to
get the receive clone windows to print correctly.
Perhaps this is only a local problem in the clones not printing my macro
message and they will receive ok when trying to copy 75 baud over the air,
but I'd rather not wait until the contest starts to find out. Anyone else
having a problem with 2Tone at 75 baud?
73,
Gary AL9A
_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty
_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty
|