Same here. Pressing escape makes it possible to use the F key once
again. I am using Winkey here.
73 de Erik, ON5AI
-----Original Message-----
From: sd-user-bounces@contesting.com
[mailto:sd-user-bounces@contesting.com] On Behalf Of IanSDavies@aol.com
Sent: zaterdag 17 september 2005 22:05
To: sd-user@contesting.com
Subject: [SD-User] Keying issue
Just been trying V12.00 and 12.01 in SAC test and have found a problem
here.
If the cursor is in the callsign field there is no problem using the F
memory keys. However if I move the cursor to the incoming serial number
field I
find that I can use the F keys once and then I get no further response
so I
have to send manually thereafter. If I rever back to the callsign field
I can
continue using the F keys again. Odd and I presume not intended!
Any suggestions?
G3KZR
_______________________________________________
SD-User mailing list
SD-User@contesting.com
http://lists.contesting.com/mailman/listinfo/sd-user
_______________________________________________
SD-User mailing list
SD-User@contesting.com
http://lists.contesting.com/mailman/listinfo/sd-user
|