Further testing:
If under device router "PTT" tab I change CW PTT to QSK or Semi Break-in
no PTT activity takes place in the Digi Keyer II and similarly Ctrl does
not lock up the PTT.
Once QSK or Semi Break-in has been enabled and used, changing the option
back to PTT has no effect until the DK II has been powered off and back on.
Once the DK II PTT locks up it can only be cured by powering down.
So is this a DK II problem or a more general Winkey issue?
Regards,
Mike VP8NO
On 06/07/2011 13:18, Raymond Phillips wrote:
> Hi Paul
> My problem still exists.
> The setup I an using is WinXP SD V15.45 with rig control KENWOOD TS480 and
> winkey, as I said earlier the minute you hit Ctrl the rig goes into TX and
> stays there you have to shut the program down for it to go back to RX.
>
> On my other rig ICOM it works fine no problems.
> Anyone using Kenwood with the same problem or is it at my end.
>
> Rgds Raymond GM0VRP
> _______________________________________________
> SD-User mailing list
> SD-User@contesting.com
> http://lists.contesting.com/mailman/listinfo/sd-user
>
_______________________________________________
SD-User mailing list
SD-User@contesting.com
http://lists.contesting.com/mailman/listinfo/sd-user
|