Many thanks to all who responded regarding the Yagi I had acquired. After a
look at the manual (thanks to Mosley) and a couple of measurements, I am now
the proud owner of a Classic 33 (CL-33M) Mosley tri-bander. I need to procure a
completely new set of stainless steel hardware which will be coming from
Mosley, and after that I can get this bad boy up in the air and start working
some serious DX.
Again, many thanks to all who took the time to reply. OBTW: the feed system is
a distributed capacitive feed designed to extend the bandwidth of the Yagi.
This thing is built like a tank. Should last me a while.
73
Rich Arland, K7SZ
Bent Dipole Ranch, Dacula, GA
"Cogito Ergo CQ" ("I think therefore I HAM")
Author: "The ARRL's Low Power Communications, the Art and Science of QRP" (all
3 editions)
Editor: "QRP POWER", QST Magazine (Jan 2000 to Dec 2003)
Editor: "The Learning Curve", CQ Magazine
Editor: "The Beginner's Column", CQ-VHF Magazine
-------------- next part --------------
An HTML attachment was scrubbed...
URL:
http://lists.contesting.com/pipermail/secc/attachments/20110801/a0f9e4b6/attachment.html
|