Can anybody think of a setting in the Ctrl-J setup that would have STOPPED
my ability to enter a frequency directly (i.e. when I type 020 "enter", the
rig should go to XX,020 mHz). It's not the program or hardware, because
direct entry works fine with the same program version on contests which are
located in other subdirectories. It has got to be a setting, or the over
writing of a setting that is nailing me. The program's frequency readout
works all the time and even the Alt-M works most of the time, but direct
entry has died. I'm stumped!? Rigs are old IC-765s
Thanks for any ideas,
Bob K5WA
|