On Sun, Oct 26, 2003 at 06:42:37PM -0500, WG0M@aol.com wrote:
> Well, things were fine during the Sprint and NAQP. SO2R worked.
>
> Then I downloaded 6.77 and 6.78 and things were never the same. SO2R did not
> work. When I switched to rig 2 and hit F1 in S&P mode, the computer sent the
> command to rig 1. All cables were checked. Computer was checked for
> problems. None were found.
Hmm - I don't see any problems here.
> I watched the monitor screen and noticed that the mode switched back and
> forth form cw to ssb. It seemed to be timed to the seconds in the clock in
> the
> upper left hand corner. I also noticed a delay between polling the frequency
> of
> either rig longer than in the past. I set the polling rate to 25 ms. That
> did not fix the problem.
This is probably a clue. This should not be happening. What type of radio are
you interfaced with? Have you tried the FILTER RADIO MESSAGE LENGTH command?
Tree
_______________________________________________
Trlog mailing list
Trlog@contesting.com
http://lists.contesting.com/mailman/listinfo/trlog
|