I am running a DOS partition on a Dell laptop (that uses Win2K otherwise).
I own a two-port PCMCIA serial card by Argosy that came with Windows and DOS
drivers. It seems to work OK under Windows (it shows up at Com5 and 6). I
use it with HyperTerminal and other terminal programs frequently at work.
But I'd like to get TR to see the card, so I ran the card's DOS
installation, but cannot get tr loopback to work.
Can someone explain the "direct" and "BIOS" request loopback makes, and/or
offer any ideas as to how to get this card to work?
Tnx,
Mike N2MG
_______________________________________________
Trlog mailing list
Trlog@contesting.com
http://lists.contesting.com/mailman/listinfo/trlog
|