On Wed, Oct 19, 2005 at 02:56:31PM -0500, James Walter wrote:
> I've recently retired the 486 computer I've been using in the shack
> and have a slightly newer Pentium computer. Recently I built the
> switch box from the schematic on the TRLog website so I can use two
> radios on phone as well as cw. I'm using the parallel port for DVK,
> Paddle Input, Footswitch Input, CW Keying and Relay control. This
> all works just fine.
> Here's the problem/question. My second radio is a Kenwood TS-850.
> I want to look at the band output from the parallel port and have a
> band decoder look at that info for a bandpass filter. Hooked that
> up yesterday and it looks at the band info but when I swap radios
> (Alt-R) the bandpass filter jumps to the band or the active radio.
I think this is a bug with 6.79
If you have 6.78 give it a try - or I can send it to you.
--
George Fremin III - K5TR
geoiii@kkn.net
http://www.kkn.net/~k5tr
_______________________________________________
Trlog mailing list
Trlog@contesting.com
http://lists.contesting.com/mailman/listinfo/trlog
|