In message Wed, 7 Jan 1998 13:45:16 -0500,
AL_LORONA@HP-USA-om33.om.hp.com writes:
> Is anyone running their Omni VI into an Ameritron AL-80B, or any
> Ameritron amp for that matter? Please rate the compatibility.
>
I run a Corsair II to an Ameritron AL-80. There is no problem it works just
fine--in fact better than the Drake C line.
> Do you run the ALC line between the two, or leave it disconnected?
>
There is NO ALC line for TenTec equipment so you MUST leave it disconnected.
What you do is set the ALC control on the TenTec so you don't overdrive the
Ameritron. Since it takes about 110+ watts to overdrive it's almost
impossible to do even with the ALC full CW.
> How about comments on Ameritron's QSK option?
Can't help you here but I don't think that you should need an amp on CW. I
never run the amp there and always get good RST reports.
>
73 Jim K4CGY
--
FAQ on WWW: http://www.contesting.com/tentecfaq.htm
Submissions: tentec@contesting.com
Administrative requests: tentec-REQUEST@contesting.com
Problems: owner-tentec@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|