Tom: Are you using the built in FSK or AFSK?
If you're using FSK, you will have to adjust the
local oscillator to the proper frequency.
Unfortunately, you may have to use 200 hz shift
instead of the proper 170 hz due to the use of those
shifts by the new gang, without realizing that the
170 hz shift was very carefully picked to minimize
intermod problems.
I've given up and gone to AFSK and then you're
TU (or controller) sets the tone frequencies.
Good luck. de KL7HF
----------
> From: Thomas A. Reilly <treilly@softdisk.com>
> To: tentec@contesting.com
> Subject: [TenTec] fsk
To: <tentec@contesting.com>
> Date: Saturday, June 06, 1998 4:52 AM
>
> I have recently started to use rtty and pactor. I have had to set the
rit
> to -.13 to be able to connect. Why?
>
> Thanks
> Tom Reilly
> W3GAT
>
>
> --
> FAQ on WWW: http://www.contesting.com/tentecfaq.htm
> Submissions: tentec@contesting.com
> Administrative requests: tentec-REQUEST@contesting.com
> Problems: owner-tentec@contesting.com
> Search: http://www.contesting.com/km9p/search.htm
--
FAQ on WWW: http://www.contesting.com/tentecfaq.htm
Submissions: tentec@contesting.com
Administrative requests: tentec-REQUEST@contesting.com
Problems: owner-tentec@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|