Jim,
I just looked in my 961 manual and it says it is rated at 20 Amps full load
and 22 Amps maximum for 5 minutes.
73, Troy, W6HV
Jimmy D. Roller wrote:
> Hi Mike, et al,
>
> For your further consideration and confusion: I have a model 960 power
> supply that I purchased when I bought the Corsair II. After losing and
> replacing the pass transistor, I made a field upgrade to the 961 using a
> kit supplied by Ten Tec. All that was required was to remove the big
> filter capacitor from the circuit board, turn it upside down and
> reconnect to the board. The manual says the 960 is rated at 22 amps, so
> I assume the 961 and 962 have similiar ratings. Aren't you glad you
> asked?! It has powered the OMNI VI(+) for a number of years including 5
> Field Days.
>
> 73,
>
> Jim, N4IR
>
> --
> FAQ on WWW: http://www.contesting.com/tentecfaq.htm
> Submissions: tentec@contesting.com
> Administrative requests: tentec-REQUEST@contesting.com
> Problems: owner-tentec@contesting.com
> Search: http://www.contesting.com/km9p/search.htm
--
FAQ on WWW: http://www.contesting.com/tentecfaq.htm
Submissions: tentec@contesting.com
Administrative requests: tentec-REQUEST@contesting.com
Problems: owner-tentec@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|