Hi Bob,
I can't find anything in the menu that must be set. One
problem with the 564 manual is that there is no overall
wiring/block schematic provided. Look at page 4-18 through
4-20 for the Logic board. On 4-18 in the right hand column,
the second paragraph explain the encoder operation. On page
4-20 in the upper right hand corner find connectors
98(Main), 80(Remote), and 99(Offset). Looks like connector
80 should go to the DB 25 (RS 232) connector. You also can't
find a complete pin connection for it in the manual. Here is
what I know abt it:
1 Grd 14 Grd
2 15
Band 6 12/10m
3 16
+5v
4 17
Band 5 18/15m
5 18
6 Phase 1 "A" 19
7 20
8 Phase 2 "B" 21 Band
4 20m
9 22
10 Band 1 160m 23 Band 3
30/40m
11 24
Band 2 80m
12 25
Unused Band 4.0-5.5 mhz
13
Hope this helps some......
de, Harry Coates WA8HC Ten Tec forever es RTTY TOO
--
FAQ on WWW: http://www.contesting.com/tentecfaq.htm
Submissions: tentec@contesting.com
Administrative requests: tentec-REQUEST@contesting.com
Problems: owner-tentec@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|