Inside the contol where the shaft goes through there is a drive gear.
Using the proper allen wrench loosen the set screw press back on the gear
sliding it back tight against the frame while pulling out on the knob
keeping the shaft foward. This should tighten the shaft. While your in
there it's a good time check the grease.
73 and Good luck Jeff aa8ve
On Wed, 24 Nov 1999 18:10:07 -0500 "K & H Darwin" <darwin@together.net>
writes:
>
> I know this has been solved on this reflector, but I didn't have the
> problem back then :) Now I do so I'd appreciate it if someone would
> clue
> me in.
>
> The resonate control on my Omni D doesn't stay put. What's the
> solution?
>
> Keith Darwin
> KD1E
> Vermont
>
> --
> FAQ on WWW: http://www.contesting.com/tentecfaq.htm
> Submissions: tentec@contesting.com
> Administrative requests: tentec-REQUEST@contesting.com
> Problems: owner-tentec@contesting.com
> Search: http://www.contesting.com/km9p/search.htm
>
___________________________________________________________________
Get the Internet just the way you want it.
Free software, free e-mail, and free Internet access for a month!
Try Juno Web: http://dl.www.juno.com/dynoget/tagj.
--
FAQ on WWW: http://www.contesting.com/tentecfaq.htm
Submissions: tentec@contesting.com
Administrative requests: tentec-REQUEST@contesting.com
Problems: owner-tentec@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|