Bill and Wilford, and the rest of the list.
Thanks. You guys both nailed it exactly. I had been hooking up a PSK31
interface to the patch in/out connections and one of the VFO connections
to the remote came out. I didn't notice that. I removed the PSK31
connections that I had just made, without curing the problem. I then
removed all connections (forgetting that a jumper was needed) and that
didn't cure the problem.
So the list help out a lot. Thanks again.
Loren
"Wilford D. Lindsey" wrote:
>
> Loren:
>
> I believe that probably the jumoer on the back has dropped out. This is
> the jumper that you use in the absence of the separate VFO. If you *do*
> have the separate VFO, make sure that it is plugged in correctly on the
> back of the main rig, etc. Could be something else, but I have had this
> same symptom under the same conditions.
>
> GL and I hope this helps.
>
> 72/73,
> --W.D. (Doc) Lindsey
> DSBF
> PO Box 6028
> Bismarck, ND 58506
> (Shipping = DSBF, 2020 Lovett Ave, Bismarck, ND, 58504)
> E-Mail = K0EVZ@arrl.net
--
FAQ on WWW: http://www.contesting.com/FAQ/tentec
Submissions: tentec@contesting.com
Administrative requests: tentec-REQUEST@contesting.com
Problems: owner-tentec@contesting.com
|