Hooking these devices up is confusing me...is it so obvious I don't see
it?
The setup: Omni-6+, 301 remote tuner, Herc II (soon).
If go from my computer to the RigBlaster directly, how do I control the
rig as I normally do?
Do I put a "y" (or is that a "W") at the RigBlaster to hook in
everything?
Do I run a separate PTT line from my W1WEF serial port interface to the
RigBlaster (which pins on the rig's RS-232 port do I use?), and then
use a separate port to control the rig? Should I use the Icom
interface for the rig?
So many options, so little clarity!
Any help is appreciated!
Eric W3DQ
--
FAQ on WWW: http://www.contesting.com/FAQ/tentec
Submissions: tentec@contesting.com
Administrative requests: tentec-REQUEST@contesting.com
Problems: owner-tentec@contesting.com
|