> --- "Dr. Gerald N. Johnson, electrical engineer"
> <geraldj@ames.net> wrote:
> >
> > Set the ALC for low output, turn down the drive so the ALC
> led
> > only flashes --- I think the unmodified Corsair's (I and II)
> are >expected to reliably go down to 7 or 8 watts.
> >
> >
My Corsair II at minimum ALC setting and drive set to just get
an
indication on the ALC LED has 18-20 watts output. Need to
change
the resistor in series with the coarse ALC pot. This is the
adjustment pot on the SWR board.
73 Jim K4CGY
__________________________________________________
Do You Yahoo!?
Get personalized email addresses from Yahoo! Mail - only $35
a year! http://personal.mail.yahoo.com/
--
FAQ on WWW: http://www.contesting.com/FAQ/tentec
Submissions: tentec@contesting.com
Administrative requests: tentec-REQUEST@contesting.com
Problems: owner-tentec@contesting.com
|