Hi Chris and Gang,
I've been very busy since Friday (wife and I had our 25th
anniversary party Saturday)and started with reading older email
about and hour ago. When I saw the link for the 1.21 upgrade I
installed it and the problems hit. The one thing I noticed was
the power problem. Tune works fine but after a 10w tune all CW
and SSB power is also at the low power tune level. In fact if you
have say 100W out and even back the power back slightly it goes
to 10W and then will not change. The only way I found to get it
back on CW and LSB was to change mode and then it would come back
to the power setting. However to get the USB back I have to
change BANDS. I had 1.21 on for about 10 minutes and reloaded
1.19.
73 Jim K4CGY
--- Chris Robson <crobson@robsonco.com> wrote:
> Just loaded the latest Jupiter firmware 1.21 and noticed that I
> had low
> output power on SSB. No amount of mic gain or processor changes
> made a
> difference. I loaded 1.19 back in the radio and all is fine. Is
> anyone else
> having this problem??
>
> 73, Chris KB3A
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
__________________________________________________
Do You Yahoo!?
Yahoo! Finance - Get real-time stock quotes
http://finance.yahoo.com
|