BTW - I'm referring to the board on an Omni VI+ :-)
----- Original Message -----
From: <tlogan7@cox.net>
To: "tentec reflector" <tentec@contesting.com>
Sent: Saturday, March 01, 2003 3:21 PM
Subject: [TenTec] no voltage to 1.8 filter?
> Hi folks -
> I've determined that the 1.8 slot on my PTB board has no voltage coming
> through the three pin connector 41 on the rear left corner of the board.
> When the 250 and 500Hz filters are engaged voltage will run through their
> respective pin on the connector - but when I turn on the 1.8 I do not get
> any voltage.
> I'm a total electronics nimno - but as far as I can tell the only
> components on this board are either chokes, toroids with binocular type
> cores, one normal toroid and three pots. So that must mean that the
> connector at 41 runs to diodes that I'm guessing are in the jungle on the
> back of the front panel - something I'm not sure I want to mess with.
> Based on this info does anybody have any additional light they can shed
on
> my 1.8 slot? It appears that it just plain does not get switched on even
> though the panel light turns on . Thanks for any help.
> 73/Tim NZ7C
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
|