| To: | <tentec@contesting.com> |
|---|---|
| Subject: | Re: [TenTec] Argo V users?? |
| From: | "Stuart Rohre" <rohre@arlut.utexas.edu> |
| Reply-to: | tentec@contesting.com |
| Date: | Tue, 10 Aug 2004 16:10:28 -0500 |
| List-post: | <mailto:tentec@contesting.com> |
Use the Ten Tec hand held mike, (a non amplified electret) and set the ALC with mike gain to where it just flashes on voice peaks. What processor setting are you using? What is your power supply, it must be 12 volts or above under load. 73, Stuart K5KVH _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TenTec] G3SJX IC-7800 review, Bob Henderson |
|---|---|
| Next by Date: | Re: [TenTec] High Tech, Low Power,& DX (My ARGO V), Stuart Rohre |
| Previous by Thread: | Re: [TenTec] Argo V users??, Mike Hyder -N4NT- |
| Next by Thread: | RE: [TenTec] Argo V users??, Larry Greenberg N5BEA |
| Indexes: | [Date] [Thread] [Top] [All Lists] |