About 100w (jus a little less than full scale).
Mark
----- Original Message -----
From: "Steve Baron - KB3MM" <SteveBaron@StarLinX.com>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Sunday, February 27, 2005 8:01 PM
Subject: Re: [TenTec] Orion Power Meter Pegging
> What did steady state power indicate?
>
> ----- Original Message -----
> From: "Mark Erbaugh" <mark@microenh.com>
> To: <tentec@contesting.com>
> Sent: Sunday, February 27, 2005 23:18
> Subject: [TenTec] Orion Power Meter Pegging
>
>
> > I just made my first CW QSO with the Orion where I ran full (100w)
power.
> I
> > noticed that at the beginning of a transmission, the meter would peg as
I
> > could hear it hitting the stop. It quickly dropped back to 100w. I was
> > transmitting into my triband beam which has a pretty low (< 1.5) SWR.
My
> > rise time was set at 8 ms, I was keying at 16 WPM.
> >
> > 73,
> > Mark
> >
> >
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
> >
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|