Good Day Members of the TenTec Reflector!
Question for you about in-rush current protection.
I leave my On/Off switch on my Omni VI+ in the ON position and turn
the rig off and on via the On/Off switch on the 961 Power supply. When
when I do turn my power on, it does seem like quite a shock to the
system.
I am wondering if there would be any benefit to inserting an In-Rush
Current Protection device between the mains and the 961 Power Supply. I
have a commercial unit I purchased some time ago to limin in-rush
current to my Heathkit SB-200 linear. I was thinking of using this and
wondering if it might provide some protection to both the power supply
as well as the Omni VI+.
Would appreciate any thoughts you might like to share on this.
Thank you and 73!
de KD4BRL Dick Knox
COL(R) Richard L. Knox
Homeland Security and Assurance
Engineering Development and Integration Services
General Dynamics
1200 Joe Hall Drive, P.O. Box 990
Ypsilanti, Michigan 48197
Tel: 734-480-5197
Fax: 734-480-5781
E-Mail: Richard.Knox@GD-AIS.com <mailto:Richard.Knox@GD-AIS.com>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|