TenTec
[Top] [All Lists]

Re: [TenTec] ORION front panel mic jack ptt voltage

To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] ORION front panel mic jack ptt voltage
From: "Carl Moreschi" <n4py@arrl.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Tue, 2 Aug 2005 08:27:47 -0400
List-post: <mailto:tentec@contesting.com>
I measure 3.92 volts beyween pin 3 and ground on my Orion.

Carl Moreschi N4PY
Franklinton, NC
----- Original Message ----- 
From: "Henry Pfizenmayer" <pfizenmayer@worldnet.att.net>
To: <orion@contesting.com>; <tentec@contesting.com>
Sent: Tuesday, August 02, 2005 12:47 AM
Subject: Re: [TenTec] ORION front panel mic jack ptt voltage


> Could someone measure the open circuit voltage they see from pin 3 (PTT)
to
> ground  for me ? My front panel PTT quit working on ssb. I measured 1.002
> volts hot after several hours and just turned it on cold and its about
0.792
> volts . I measure just over 4 volts open circuit on the AUX/IO PTT dongle
> from the rear panel (black connector) . Obviously if front panel pin 3 and
> back panel IO are supposed to be hardwired together -it is not happening
now
> ! Shorting pin 3 to ground does not enable PTT - so its not a mic cable/
mic
> sw problem.
>
>  The thing transmits  SSB with the rear  IO black connector closed and it
> also keys fine on CW . I tried all the combinations I could think of in
the
> SSB PTT menus (found in CW menu ) . VOX works fine also.
>
> Thanks - Hank K7HP
>
>
>
>
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>