I don't have an Orion Mark, but I've read about Heil mics and headsets
working well with the Orion. I'm sure you should be able to have the same
success. The Orion is used as contest rig, and I would think Ten Tec would
make it compatible with the Heil headset, since I would say the Heil Headset
is the most popular headset in contesting. Not the only one, but I would bet
the most popular.
GL & 73
Mike, K9MI
----- Original Message -----
From: <k8vf_mark@centurytel.net>
To: <tentec@contesting.com>
Sent: Saturday, September 02, 2006 04 12
Subject: Re: [TenTec] Orion Mic Woes - Sounds like RFI but Wasn't
I just got an Orion which I bought used.
In an effort to be ready, I took one of my 4 mics used on my Omni VI, and
V,
and Paragon II, and removed the shield from pin 2 and attached it to the
connector case.
Mic is unuseable. On Dummy LOAD. This is not an rf issue here.
Put the shield back on pin 2 where it was on all of my other TT rigs,
sounds
fine.
The Ten Tec model 700 I have does not have the shield to the case, it
works
fine.
My Heil proset sounds terrible. I moved the shield from pin 2 to the
connector case, still sounds terrible.
Again, all of this is on the dummy load.
A question on mic cables.
Except for a D-104, all mics I have seen have 3 wires plus shield.
Usually white for mic audio, red and black (or blue) for PTT and shield is
mic ground.
I dont recall ever seeing a separate shield that is not mic audio return.
My Ten Tec mic does not have this extra wire, nor does my MC-50.
What procedure should we use with 3 wires plus shield(mic return) mics?
In my reading on this issue, I dont get a definitive answer. (possible
I've
missed something).
I just want the Heil Proset to work on the Orion like it has on many other
rigs.
Thanks in advance.
Mark
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|