Denton
Join the Omni VII users group. Read through some of the earlier emails .There
are a lot of work arounds for getting the OnePlug GUI running .
http://groups.yahoo.com/group/Ten-Tec-Omni-VII/
Also download the OnePlug users guide. If you haven;t already.
http://rfsquared.com/Updates/588/588 .
It's at the botton of the page
73
John WB4QDA
----- Original Message ----
From: Denton <denton@oregontrail.net>
To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Sent: Tuesday, May 22, 2007 8:53:09 AM
Subject: [TenTec] Omni 7 ethernet port and One Plug program problems?
Hi all..gotta a couple of problems with my slightly used Omni 7...and I
don't think it's the rigs' fault.
When I try to run One Plug, I get a "run time error 13, type mismatch"
message on screen instead of the programs start gui.
When I try to hook up a cross over ethernet cable to a second ethernet port
in my pc to the Omni 7, the port and omni seem to talk to one another, but
no data flows, irregardless of deligent internet address designation in the
Omni's menu.
Any workarounds? will probably call TT later this am....
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
____________________________________________________________________________________Yahoo!
oneSearch: Finally, mobile search
that gives answers, not web links.
http://mobile.yahoo.com/mobileweb/onesearch?refer=1ONXIC
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|