Re: [TenTec] Orion II max Power

["pfizenmayer" <pfizenmayer@qwest.net>]

Duane  / Fotis - Turns out I have been looking at the 566 PA module for some 
different reasons than getting more power - but - the output devices are 
pushpull 2SC2290 bipolars - the driver for that stage is a push pull pair of 
FETS the RD16HHF1 - this is for the ORION II 566. (drivers are a  change 
from the 565 Orion)
And the Toshiba data sheet shows typical 60 W PEP output at 10 meters at 
12.5 volts but looking at Po curves  there is an inflection around 50 watts 
out at 12.5 - Most Orions are probably running at more like 13 to 13.5 volts 
at the PA at 100 watts so that inflection is probably a little higher. The 
data sheet does not show any "maximum" ratings  but I sure would not play 
wih running it at more than 100 watts  for the pair. You could probably get 
120 -130 watts but what is the point . I have seen over 130 watts at 160 and 
80 accidentally during my project but have it set at 100 watts .
Incidentally the FET drivers are massive overkill so they are not a limit 
(assuming the load lines are low enough with the present interstage 
transformer ).
I fully agree - if you want more power out - get an external amp of some 
sort and let the Orion loaf. I would not mess with increasing the output no 
matter what WIKI says.
73 de Hank K7HP