[TenTec] Carrier null on Omni VI; SSB switching transient

[W5OT@aol.com]

My Omni VI has a small bit of carrier showing on LSB that is not present on  
USB.  Also there is a full output switching transient when I key the mike  in 
LSB; it is less than half on USB.
 
Can this alignment/null be performed with a minimum of test  equipment?  I 
don't have a service monitor capable of 1 Hz readout.  I  seem to remember some 
discussion on the switching transient a few years ago, so  I will try to check 
the archives.
 
73, John
**************New Low Prices on Dell Laptops – Starting at $399 
(http://pr.atwola.com/promoclk/100126575x1220631247x1201390185/aol?redir=http:%2F%2Fad.doubl
eclick.net%2Fclk%3B213540506%3B35046329%3Bx)