I would say that the core should not be greased. If assembled correctly,
it should not rub on the inside of the coil form.
73,
Bob WB2VUF
Andrew Moore wrote:
Finally rebuilding the Triton 540 PTO here.
Step says to grease the threads inside the pistol. Done. But are you
supposed to also grease the outside surface of the 1/2-inch or so diameter
core (medium gray color, with ribs) which moves in/out of the PTO coil? I
don't recall degreasing the inside of the PTO core when I took all this
apart (been a couple months) so I'm guessing no but wanted to check with the
list.
Thanks,
--Andrew
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|