Have you done a complete reset to the Orion?
1) Power off Orion.
2) Power On holding the VFO B LCK button.
3) Continue holding LCK button until the radio says "Battery Failure".
4) Power off Orion.
5) Power on holding "Main RX/TX" button.
6) Continue holding this button until the radio says reset complete.
7) Do not clear any settings when asked to do so.
8) Power the Orion off and back on one more time.
73,
Carl Moreschi N4PY
121 Little Bell Dr
Hays, NC 28635
www.n4py.com
----- Original Message -----
From: "Jim Brown K9YC" <k9yc@audiosystemsgroup.com>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Wednesday, April 28, 2010 6:30 PM
Subject: Re: [TenTec] Orion II 15 m CW Transmit Power Fluctuation
> On Wed, 28 Apr 2010 09:51:41 -0700 (PDT), Kimberly Elmore wrote:
>
>> Ron, the problem persists even at reduced power settings.
>
> I forgot to mention, but i should have -- if the problem presists at very
> low
> power levels, it's VERY unlikely to be RFI.
>
> 73,
>
> Jim K9YC
>
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|