Re: [TenTec] Orion ll Firmware 2.044A Will Not Load

["Gene Henderson" <wb9hla@comcast.net>]

Make sure all of the other programs are shut down then try to update.  Gene 
WB9HLA
----- Original Message ----- 
From: "RM" <royalct@myfairpoint.net>
To: <tentec@contesting.com>
Sent: Sunday, June 20, 2010 19:18
Subject: [TenTec] Orion ll Firmware 2.044A Will Not Load


> Current Firmware Version installed is 2.06b14
>
> In trying to install 2.044A, I consistently receive the error 
> Communications
> with the radio failed, and so on.  I'm using a USB to Serial Port 
> converter
> which has been running with this radio without any problems.  In fact, I
> loaded 2.06b14 using this setup.
>
> I don't believe it's the USB-to-Serial converter, since I control the 
> radio
> and logging functions with DxBase 2007 without any issues.  (baud rate set
> to 57600, Word Length set to 8, Stop Bits set to 2, and assigned to 
> comport
> 5). I've not had any problems loading the previous versions with the
> USB/Serial converter, or any problems with DxBase at the above settings.
>
> Any suggestions would be greatly appreciated.
>
>
> Ron / NU1U
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec