Re: [TenTec] Ten Tec 961 schematic

["Tim Heasman" <tim@sideswiper.plus.com>]

Hi All,

I run an Omni VI opt3 on a 961, and that also runs much hotter than I 
expected.  I do not remember the Omni V or Paragon doing the same.
73

Tim

gm4lmh

--------------------------------------------------
From: "W8BVH" <w8bvh@sbcglobal.net>
Sent: Sunday, July 04, 2010 7:18 PM
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: [TenTec] Ten Tec 961 schematic

> Who was looking for a schematic for a 961 powersupply?? I have a pdf 
> manual.
> Best regards,
> Ralph Howes
> W8BVH
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec