In 2.041XT, the waterfall was not instead of the sweep display, it was a
menu-driven option. If you would rather have the sweep display, you could
choose that. What I liked about the waterfall was that it followed CW
signals almost instantaneously, much faster than the sweep in 2.044A. I
admit,
though, that it wasn't so great on SSB.
73 Ray W2RS
In a message dated 2/18/2011 10:27:44 P.M. GMT Standard Time,
w3krq@dejazzd.com writes:
I DID NOT LIKE THE WATER FALL AS SOON AS I SAW IT I WENT BACK TO THE OLD
UPDATE. AND I AM NOT THE ONLY ONE.
-----Original Message-----
From: Rsoifer@aol.com
Sent: Friday, February 18, 2011 5:00 PM
To: tentec@contesting.com
Cc: jhenry@tentec.com
Subject: [TenTec] Orion II
Hi John,
I hear you about the 566. V2.044A is very good, but please don't forget
about the waterfall display. I'm not at all convinced I would want a high
speed sweep board, but I did like the old waterfall.
73 Ray W2RS
In a message dated 2/18/2011 9:47:39 P.M. GMT Standard Time,
jhenry@tentec.com writes:
Hi Bill,
It is on the 9 meg IF board.
Board # A4
Sub assembly # 81910
73, KI4JPL
John Henry
TenTec Engineering
Could someone please tell me on which board the hardware noise blanker
is located in the Orion I?
Thank you.
Bill AD8P
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|