[TenTec] 565 firmware update - receive audio

["John K Gotwals" <john@gotwals.com>]

Yesterday I installed the 565 2.064X11 firmware update followed by the RAM 
Clear and Master resets. In general, things seem to be as expected except 
for the main receive audio. I operate on 75 and 40 meters phone and when 
conditions permit I have my receive bandwidth set at 3000 (Rx Eq = 0dB). I 
immediately noticed that received signals of stations I had worked 
previously are lacking in lows. When I set PBT to -200, the received signal 
sounds normal. Has anyone else noticed this in the new firmware, or is it a 
case where I should do another round of resets?
John, N9JG