On 03/20/2011 12:48 PM, pfizenmayer wrote:
> By any chance do you have the RX>BW track or RX>PBT track turned on ? That
> might be doing it .
>
> Hank K7HP
>
> ----- Original Message -----
> From: "John K3GHH" <k3ghh@arrl.net>
> To: <TenTec@contesting.com>
> Sent: Sunday, March 20, 2011 5:10 AM
> Subject: [TenTec] Default LCW BW 1000Hz
>
>
>> After a recent update of O2 firmware to 2.044A, when I first turn the
>> rig on its bandwidth (on LCW mode) is 1000 Hz. When I turn the rig off
>> the bandwidth is usually 500 Hz and often less --- certainly never
>> anything near as wide as 1000. How do I change this boot-up default
>> bandwidth?
>>
>> --
>> John K3GHH
>>
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
Thanks, Hank... but they're both off.
--
John K3GHH
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|