TenTec
[Top] [All Lists]

Re: [TenTec] ORION 565

To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] ORION 565
From: "Holger" <dj8hb@kcag.de>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Mon, 21 Mar 2011 07:20:29 +0100
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
Hello Rick
Many Thanks for your helpfull Letters. I hope it can be fixed these with new 
Capacitors. Yes i know, the Capacitors are very important, but for me this 
is a new situation with this ORION. Maybe a Ceramic- Capacitor parrallel to 
the new 470µF is also helpfull.
Before i has used the FT990 and FT1000D for CW very bad, the TS930S from 
Kenwood is mutch better, like perfect. Now the Orion with Dual-Receive anf 
less Oszillatornoise beat the TS930S.
73
Holger
DJ8HB
cw4ever
eof


----- Original Message ----- 
From: "Rick W" <ve7tk@yahoo.ca>
To: "Ten-Tec Reflector" <tentec@contesting.com>
Sent: Sunday, March 20, 2011 4:22 PM
Subject: Re: [TenTec] ORION 565


> Holger I wonder if it might be the power distribution board.  The power
> distribution board is a very simple fix.  You replace 3 electrolytic
> capacitors.  You should try and get good quality, low ESR value caps with 
> a
> HIGHER voltage rating than the original.  Ron, N6IE, describes the fix on 
> his
> website.
>
>    http://www.n6ie.com/A9_Fix.html
>
> Even if this is not the problem it is good to do the fix
>
> Good luck.
>
>
> 73,
> Rick
> VE7TK
>
>
> Website:  http://www.ve7tk.com
>
> ---------------
>
> To: <tentec@contesting.com>
> Subject: [TenTec] ORION 565
> From: "Holger" <dj8hb@kcag.de>
> Date: Sun, 20 Mar 2011 11:17:18 +0100
> Hello
> Now i am a proud Owner from the famouse ORION 565, make the Softwareupdate 
> to
> the latest  Version 2.064XX11 and DSP 2.08b84, the Results now is 
> fantastic.
> But, sometimes after switched on the Orion I, the Display with all 
> Information
> are not coming on ,only white Display, Boot- Error or is this normal ?
> These Troubble i has had also before i make the above Update !
> Perhaps some Voltages inside are not correct?
> Maybe Help is possible?
> 73
> Holger
> DJ8HB since 1962
> eof
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec 

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>