My OMNI VI+ (and ORION II and FT-1000MP) communicate with a standard RS-232
serial port on every computer I've used them with.
For computers without an RS-232 port with USB ports only, a USB-to-RS232
adapter with FTDI chipset works without any problems.
73,
Marsh, KA5M
-----Original Message-----
From: tentec-bounces@contesting.com [mailto:tentec-bounces@contesting.com]
On Behalf Of Clayton Brantley
Sent: Tuesday, March 29, 2011 8:18 AM
To: Discussion of Ten-Tec Equipment
Subject: Re: [TenTec] Serial Interface between Omni VI+ and computer
Ric: My OmniVI has a 25 pin RS-232 port and works without a level
converter.
Clayton N4EV
________________________________
From: RICHARD GUIDONE <richardvalerie@rogers.com>
To: tentec@contesting.com
Sent: Mon, March 28, 2011 8:37:10 PM
Subject: [TenTec] Serial Interface between Omni VI+ and computer
Thanks to all who responded to my questions. I will now build the level
converter in the 9 pin case and see if that solves the problem.
If not I will be back for more help.
Thanks again and best 73
Ric - VE3XL
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|