That depends. What did the loud pop smell like?
I'd give it a real close looking over and under, inside and out, mostly
inside, before putting power to it again. I suspect you'll find
something burnt.
Dave KC2RPJ
------------------------------
> Date: Sat, 30 Apr 2011 21:09:00 -0500
> From: "Art Trampler"<atrampler@att.net>
> Subject: [TenTec] ooops!
> To: "Discussion of Ten-Tec Equipment"<tentec@contesting.com>
> Message-ID:<001701cc07a4$bd522510$37f66f30$@att.net>
> Content-Type: text/plain; charset="iso-8859-1"
>
> The joys of getting old?
>
> I went to tune my 425 and had the Pegasus output set for 20 watts.
>
> Well, I forgot to check the output when using the ?Tune? button, and that was
> 100 watts. There was a loud pop (not a snap, mind you) in the RF deck and the
> main fuses blew. Just in case, I replaced the fuses and as soon as I hit any
> drive, the same ?pop? and blown fuses.
>
> I would say the fault occurred about one second into the overdrive. I
> couldn?t get the mouse on the button quickly enough to prevent it.
>
> So what?s the consensus? Tubes only? Or do I look for something else as well?
>
> Thanks,
>
> Art
>
> Art Trampler, K?RO
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|