Has anyone used one of the high-energy, multi-farad capacitors (used by the
car-audio crowd), near the amplifier to support amperage peaks, and avoid
voltage drop? Just curious, mostly.
73-
Greg, KC8HXO
--- On Mon, 6/20/11, Ken Brown <ken.d.brown@hawaiiantel.net> wrote:
> From: Ken Brown <ken.d.brown@hawaiiantel.net>
> Subject: Re: [TenTec] paralleling power supplies to run Herc II
> To: k9yc@arrl.net, "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
> Date: Monday, June 20, 2011, 4:42 AM
>
>
>
> > On 6/19/2011 2:24 PM, Allan Taylor wrote:
> >> I finally picked up a 2nd 50A Astron power supply
> to make a pair. Are
> >> there any issues in paralleling these to run the
> Herc II? I am going
> >> to verify that the terminal voltage is identical
> within .01V.
> >
> > I did that and it worked just fine. The Herc II
> power connector is
> > wired so that you can easily have one of the supplies
> feed half of the
> > amp and the other supply feed the other half. I
> DID strap the
> > regulators together, using the banana connector.
> I ran two #12 reds and
> > blacks from each supply to the amp to keep the IR drop
> low. I used two
> > RS70s. One was NOT enough. :)
> >
> > Astron RS50 are not rated at 50 amperes continuous,
> but rather 50 amps
> peak. Exactly what that means as I do not know. I suspect
> that two
> Astron RS50 power supplies may work with a Hercules II in
> SSB service,
> as long as there is not much compression used. Higher power
> density
> resulting from an RF speech processor or other processing,
> or even the
> dahs in low speed CW could be problematic. Please let us
> know how it
> works out.
>
> Two RS70, which claim 70 amps peak and 50 amps average,
> would be a
> better choice.
>
> DE N6KB
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|