In response to my question of TT providing a pan adapter in the near
future several people responded ( thank you ) telling me how they sent
there OII back to the factory and have them pull out the IF to a extra
port on the back of the radio . OK , sounds good anyone remember about
how much the mod cost ? what software and hardware do I need to make
this pan adapter work ? I assume that the hardware extracts the IF info
and sends it to my computer where a special software program turns it
into a pan adapter . Is this correct ? If so any suggestions on the
best route to take ? thanks again to you tech guys ! John molenda kb2huk
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|