According to the manual, there are 4 lamps that feed from the QSK board +12
line. Don't remember off hand
what the 12 equivalent of the old #47 6 volt lamp is, but should work. Manual
also mentions that the meters are
internally illuminated. Might be worth a call to 865-428-0364 and I'm sure
someone there will tell you EXACTLY
what you need.
Clayton N4EV
________________________________
From: Gene Henderson <wb9hla@comcast.net>
To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Sent: Wednesday, December 28, 2011 3:14 PM
Subject: Re: [TenTec] Centurion meter lamps
Ernie I have tried to find them also and they are not in the manual,. Gene
WB9HLA
----- Original Message -----
From: "k2ep" <k2ep@nycap.rr.com>
To: <TenTec@contesting.com>
Sent: Wednesday, December 28, 2011 14:53
Subject: [TenTec] Centurion meter lamps
> Picked up the lamps from NAPA and they work fine. If they are listed in
> the manual, I can't find them. It's nice to have them in your hand before
> taking all those screws out. The price for 4 was $9 and change.
>
> Tnx, Ernie K2EP
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|