Herman,
The 936 matched the Delta II - I bought both at the same time and that is
the way the TenTec catalogue at that time showed it.
The power cord is a three wire type molded into the usual plug. The output
to the rig has the standard TenTec two wire plug that also was used up to
the Argonaut V. IMHO the Ga of the output wire for the Delta II should have
been larger - it looks like #14 stranded (but I could be wrong) I have had
the replacement of that on my list of "to dos" for a while - use it every
day and no problems.
It was made so that you could change the input from 120 to 220 V so there
are jumper in there.
I do not have a schematic for the 936 or I would scan it and send it to you.
Good luck with it,
73 Kris KM2KM
----- Original Message -----
From: "Mike Herman" <oldwatchmaker@gmail.com>
To: <tentec@contesting.com>
Sent: Sunday, September 16, 2012 3:11 PM
Subject: [TenTec] TenTec 936 PS
Ten tec friends-
Bought a well used TEN TEC 936 power supply at a local Hamfest and of
course it had several changes...did the 936 have a 4 wire or 2 wire power
cord??? Was the matching radio a Delta 2??? a 2 wire connector??? did it
match the early grey Jupiters??? ( it looks close to me) I am just curious
I looked at the TenTec web site and no 936 was listed on the expired rigs
list of schmatics ??? 73 and thanks for any comments
n9nf mike
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|