Rick - is it offset between receive and transmit?
Otherwise, how did you discover that it is "off?" and what does that mean
exactly?
Bry AF4K
---- Rick W <ve7tk@yahoo.ca> wrote:
> Well after further examination this is NOT where I need to be - hi. It looks
> like that is the locking crystal for all the "logic" - duh!
>
> More serious examination is in order!
>
> 73,
> Rick
> VE7TK
>
> Website: http://www.ve7tk.com
>
>
>
> >________________________________
> > From: Rick W <ve7tk@yahoo.ca>
> >To: Ten-Tec Reflector <tentec@contesting.com>
> >Sent: Thursday, December 27, 2012 4:45:03 PM
> >Subject: Omni VI Frequency Adjustment
> >
> >
> >I have recently acquired and Omni VI. The rig has seen little use in the
> >last 10 years but it is working VERY well with a minor exception. The rig
> >is slightly off frequency (about 150 Hz) - even after a significant warm-up.
> >
> >
> >Looking at the schematic, I have found the crystal oven on the Logic Board
> >(81606). It looks like the crystal frequency can be tweaked with C31. This
> >is an early O-6 and it has the crystal oven.
> >
> >
> >Other than C31, are there any other adjustments I should be considering?
> >
> >
> >Thanks.
> >
> >73,
> >Rick
> >VE7TK
> >
> >Website: http://www.ve7tk.com
> >
> >
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|