TenTec
[Top] [All Lists]

Re: [TenTec] Paragon II Failure to Transmit

To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] Paragon II Failure to Transmit
From: GARY HUBER <glhuber@msn.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Mon, 14 Jan 2013 21:25:44 -0600
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
Rick,

As a former Paragon owner (with a similar experience as yours about twelve years ago), I believe the OMNI-VII (my current primary radio) with at least the 500 Hz mechanical filter will satisfy any requirements you have for the Paragon.

Full disclosure: I am a TenTec Ambassador, if you use my name you receive free shipping on your order of an OMNI-VII and I receive $40 after you've made final payment. The 30 day free trial also applies.


Best regards,

CSM(r) Gary L Huber - AB9M
9679 Heron Bay Road
Bloomington, IL 61705

WWW.CSM-GH.COM
glhuber@msn.com
309-662-0604

-----Original Message----- From: rrbunn@cox.net
Sent: Monday, January 14, 2013 12:56 PM
To: tentec@contesting.com
Subject: [TenTec] Paragon II Failure to Transmit

Folks, My beloved Paragon II (I've had it for 15 years) locked up after i got back from 3 weeks vacation. Power supply was on but the radio was off and antenna grounded. When I first powered it up the reciever acted as it should but no audio out of the speaker. I turned both the radio and power supply off and restarted. This time I got 67.34&&& on the display (I cannot replicate the other characters)and it would not reset. I called Ten Tec and they told me to pull the RAM/ROM board and reseat which I did. Now the radio receives but will not switch to transmit with either TUNE, Hand Mike, Desk Mike or CW key. the audio drops down but the rest of the radio does not go into transmit. Ten Tec is sending ne a new CPU battery, I don' t know if this well help, but...

Any other ideas?

I am interested in buying a new radio and all three of the Ten-Tecs look good. Any idea of comparison to the Paragon II in terms of the Sherwood specs list?

I am an engineer and extra class ham, but the more I read the more confused I get. I want to be able to contest and DX as well as rag chew. Your recommendations are welcome.

73 Rick
N4ASX
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>