I have 2 Scouts one base 1 nobile and will a Kenwood MC nic work? If so would
like to know wiring change or if not what would work well. 73
Jim and the Girls
________________________________
From: Stuart Rohre <rohre@arlut.utexas.edu>
To: Jim Hicks <n7ino@yahoo.com>; Discussion of Ten-Tec Equipment
<tentec@contesting.com>
Sent: Monday, February 11, 2013 2:42 PM
Subject: Re: [TenTec] Scout drifting on SSB
Yes there are some fixes for the Scout PTO with NPO capacitors.
However, first make sure the band module plugs in snugly on every contact to
the edge card traces. Make sure internal grounding screws are tight both in
the rig and in the band module. Loosen and retighten to break oxides that
build up over time in Aluminum.
There were some fixes posted to either this reflector, (see archives), and/or
QRP-L back 10 or more years.
Good Luck,
Stuart Rohre
K5KVH
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|