Terry,
I am trying to imagine in my head how this is going to work. I believe
you are referring to the AUX RX receive antenna.
IF I use this connector and it's cabling to make a break and insert
the ANC 4 into the line, I would have to have the RX ANT turned on the
front panel at the same time as I have my TX ant ANT 1? Does the keying
relay for ANT 1 work to switch RX ant at the same time? I assume so.
OK, since by turning on the AUX RX ant, I am depriving myself of being
able to use the main RX/TX antenna on ANT 1 since the RX AUX ANT is
being switched in. I am not wanting to TX on the AUX RX ant and if the
RX ant is switched on that is what would happen ( unless I have this
all wrong with my logic....(.where is spock when you need him)
Terry???
Toby K4NH
On 4/7/2014 8:38 AM, Zivney, Terry wrote:
There are alternatives to drilling holes in the Orion series for a receiver
loop.
There is a receiver input already on the back panel. There is a spare
RCA jack on the rear panel (many use it for LP-Pan interface).
Terry N4TZ
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|