TenTec
[Top] [All Lists]

Re: [TenTec] RX366 9 MHz Out

To: "TenTec@contesting.com" <tentec@contesting.com>
Subject: Re: [TenTec] RX366 9 MHz Out
From: P C A <xtraham58@hotmail.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Tue, 13 May 2014 17:18:36 -0400
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>

> None, but I still will not spend any more money on it. I do not have the 
> RX366.
Andy, W3LI
> 
> What new, superior radio are you using instead of your OrionII Andy?
> 
> Barry N1EU
> 
> 
> On Tue, May 13, 2014 at 9:12 PM, P C A <xtraham58@hotmail.com> wrote:
> 
> > Kim, can not understand why you would spend the money on a dead horse. The
> > Oll is obsolete, I know I own one.Andy, W3LI
> >
> > >
> > >
> > > Kim, FYI I posted to this list about my lack of success using the RX366
> > > 9MHz output to drive LP-PAN (w preamp).  I believe the VE7TK mod that
> > adds
> > > a Clifton Labs buffer amp to generate the 9MHz output will probably yield
> > > much more satisfactory results.
> > >
> > > 73/GL,
> > > Barry N1EU
> > >
> > >
> > > On Tue, May 13, 2014 at 1:36 AM, Kim Elmore <cw_de_n5op@sbcglobal.net
> > >wrote:
> > >
> > > > I've just finished the installation of my new (and, apparently last)
> > RX366
> > > > into my Orion II. Being the kind of ham that wants to have all the
> > bells
> > > > and whistles available, even if I don't have the ability to use them
> > right
> > > > now, I decided to go ahead and take advantage low-level the 9 MHz
> > output
> > > > from the RX366. I obtained a length of coax with TMP connectors on both
> > > > ends and looked up the 9 MHz output mod by VE7TK. To my astonishment,
> > I see
> > > > that one of the unused TMP receptacles on the back of the unit (the one
> > > > next to where cable 3 plugs in) goes to the RCA jack on the back
> > labelled
> > > > "SPARE." I double checked and, sure enough, there's a DC path to the
> > > > "SPACE" RCA jack on the back. KEWL!
> > > >
> > > > So, apparently, all I need now is an LP PAN adapter unit with a preamp
> > and
> > > > I'll be cookin' with a real-time spectrum display.
> > > >
> > > > Kim N5OP
> > > >
> > > >
> > > > _______________________________________________
> > > > TenTec mailing list
> > > > TenTec@contesting.com
> > > > http://lists.contesting.com/mailman/listinfo/tentec
> > > >
> > > _______________________________________________
> > > TenTec mailing list
> > > TenTec@contesting.com
> > > http://lists.contesting.com/mailman/listinfo/tentec
> >
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
> >
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
                                          
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>