I doubt the operator who complained about high repair costs has had to
deal with Icom. A diode went out in my PW-1 and caused the finals to
blow. Over $1200 later and I was back on the air!
73, George K4GM
On 8/8/2015 3:45 AM, Onno PA1AP wrote:
Replacing the logic board is an expensive step. It contains the cpu, both
dsp's and most other logic. Despite a high repair bill I dont think ten tec
tried to make a business case from this.
>From what I understood some components are hard to replace because they
became obsolete. Only option to repair is replace with inventory boards,
hence the higher cost.
Regards, onno pa1ap
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|