I drove over to friend house and got the print out.
-----Original Message-----
From: Rodney
Sent: Tuesday, April 12, 2016 4:28 PM
To: Discussion of Ten-Tec Equipment
Subject: Re: [TenTec] 709 mike
I received a 709 with connector cut off, I have no manual, I am getting a
omni v11 in a week from know I am trying to get mike ready.
-----Original Message-----
From: P C Andy Anderson
Sent: Tuesday, April 12, 2016 3:54 PM
To: Discussion of Ten-Tec Equipment
Subject: Re: [TenTec] 709 mike
Do you have the manual? They are shown there.
Andy, W3LI
________________________________________
From: TenTec <tentec-bounces@contesting.com> on behalf of Rodney
<w3krq@dejazzd.com>
Sent: Tuesday, April 12, 2016 3:30 PM
To: TenTec@contesting.com
Subject: [TenTec] 709 mike
what is the mike 709 connections for ten tec orion
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|