yeah, I garner that…
I surmise just about any common 12 vdc 30 amp relay will do the job also. Will
know more when I pull out the relay board this winter. Will upgrade the dc
power plug to an anderson power pole or something that is more current capable
at same time.
> On Dec 11, 2016, at 10:23 AM, Mike Bryce <prosolar@sssnet.com> wrote:
>
> Yup! It’s a PB T90 series
>
> MIke, WB8VGE
>
> Mike Bryce
> prosolar@sssnet.com
>
> “The trouble with quotes on the Internet is that you never know if they are
> genuine”
>
> —Abraham Lincoln
>
>
>
>
>
>
>
>> On Dec 11, 2016, at 10:35 AM, denton sprague <denton@oregontrail.net> wrote:
>>
>> Can anyone tell me if TT uses the potter & brumfield T90 series part no.
>> 475161 relays in both the Orion I and II rigs?
>> got this relay number off of a listing for an Orion I being parted out on
>> eBay.
>>
>>
>>> On Dec 10, 2016, at 8:43 AM, denton sprague <denton@oregontrail.net> wrote:
>>>
>>> If I slap the top of the Orion the relay will switch to off…when the power
>>> switch is in off position.
>>> Methinks mechanical…will know for sure when I pull out the relay board.
>>>
>>>> On Dec 10, 2016, at 8:25 AM, Steve Ellington <steven4lq@gmail.com> wrote:
>>>>
>>>> Measure the voltage across the relay coil and see if it's being hung up by
>>>> voltage or just a mechanical problem.
>>>> Can you pull the cover off the relay?
>>>> Steve N4LQ
>>>>
>>>> On Sat, Dec 10, 2016 at 11:23 AM, denton sprague <denton@oregontrail.net>
>>>> wrote:
>>>>
>>>>> After several months of flakiness, the dc power relay in my Orion II
>>>>> decided to pretty much stay closed (on) all the time despite the front
>>>>> panel on/off switch position.
>>>>>
>>>>> Sometimes the relay will stay on for a few minutes, with the power switch
>>>>> in off position, then the relay will switch off.
>>>>>
>>>>> Shutting off the power supply itself until the Orion cools down just
>>>>> about always put the relay in the off position.
>>>>>
>>>>> So assuming the relay is just about toast, I am looking for the
>>>>> aftermarket part number and where to get the dc power relay…
>>>>>
>>>>> Anything else other than the relay that could be causing the problem?
>>>>>
>>>>> The power switch seems to be ok.
>>>>>
>>>>>
>>>>> _______________________________________________
>>>>> TenTec mailing list
>>>>> TenTec@contesting.com
>>>>> http://lists.contesting.com/mailman/listinfo/tentec
>>>>>
>>>> _______________________________________________
>>>> TenTec mailing list
>>>> TenTec@contesting.com
>>>> http://lists.contesting.com/mailman/listinfo/tentec
>>>
>>> _______________________________________________
>>> TenTec mailing list
>>> TenTec@contesting.com
>>> http://lists.contesting.com/mailman/listinfo/tentec
>>
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|