[TenTec] Orion II Display problem?

[Rod Greene <w7zrc@yahoo.com>]

During SSCW I noticed (after a few hours of operating) the number 9 creeping in 
from the right side of the display. It never completely became visible, but was 
definitely there and in large font. Later on in the SS a third megahertz number 
appeared on top of the regular megahertz numbers for each VFO. I could correct 
this easily by turning the OII off and back on. I was using N1MM+ in SO2V mode. 
Any thots on this or other similar experience? I have replaced the A9 board 
caps last year. And the display is working fine today.
Thanks and 73, Rod/w7zrc