no it was 190 m with no drive and tubes got red
-----Original Message-----
From: Bob McGraw K4TAX
Sent: Wednesday, August 08, 2018 8:53 PM
To: tentec@contesting.com
Subject: Re: [TenTec] centurion
Is this idle current with no signal? If so it is about correct.
73
Bob, K4TAX
On 8/8/2018 7:42 PM, Rodney wrote:
I was on my Centurion talking and looked at my plate current it was
resting at 190m but the amp was putting out 1200w so tubes I think are ok.
---
This email has been checked for viruses by AVG.
https://www.avg.com
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|